lurther..

Status
Not open for further replies.

benja

Village Elder
#1
since youve done wide research on electronics kindly tell me a solution to this prob..
how does one remove the small probe of an Rca cable which broke and stuck inside the audio port of an LED screen..
 

benja

Village Elder
#3
davidee i opened the unit and discovered its soldered firmly to the motherboard nikaona soldering inaeza niletea problems..
 

benja

Village Elder
#6
Davidee i see we think a like i tried but nikaona the biro tube was hollow hence i looked for a toothpick cut it and stuck it for a few minutes haikutoka did it again but these time ive left it for some time nione ka itatoka...
 

vuja de

Village Sponsor
#7
1. Get a paper clip and straighten it out. Make a slight curve (about 30 degrees), 3 mm from one edge
2. Grip it using a pliers and heat it on [important] a gas cooker flame till it's red hot
3. The broken RCA terminal should be metallic cased, and plastic inside. Insert the hot tip inside the plastic and allow 1 minute for cooling
4. Pull out the broken tip
5. Thank me later
 

Who will win the 2022 elections? Ruto vs Raila.Cast your vote!

Status
Not open for further replies.

Who will win the 2022 elections? Ruto vs Raila. Cast your vote!

Top